NAM Type: EEPROM
Manufacturer: Citicomm
Programmer: Keypad with cradle jumper installed
ESN Prefix DEC: 163
HEX: A3
ESN, S/N Match Required: Yes
Available Channels: 832
Programming Sequence: Open cradle and insert a jumper wire from
contact #8 to contact #10 on cradle
PC board (see schematic next page)
Power On
Press * + * + # + # + FCN + STO (within 10 seconds
to enter program mode)
Enter NAM option 0, 1 or 2
0 NAM 1 only (lock out NAM 2)
1 Program NAM 1
2 Program NAM 2
Enter parameter for each step then press STO to
store increment
CLR key corrects data before STO is pressed
Press SEND to write data in NAM
System ID Format: 5 XXXXX + STO
Local Use Option: 1 1 + STO
MIN Option: 1 1 + STO
Mobile Number: 10 XXX-XXX-XXXX + STO
Station Class: 2 08 + STO
Initial Paging Channel: 4 0333 or 0334 + STO
Access Overload Class: 2 XX + STO
Preferred System: 1 0(B) or 1(A) + STO
Group ID Format: 2 XX + STO
Press SEND to write data in NAM.
New Unlock Code: Current 4-digit unlock code + FCN + 0
+ new 4-digit unlock code
System Select: 4-digit unlock code + FCN + * + * + *,
etc. (the following options will be
displayed) + STO (to enter selection)
© 1994-1996 Copyright Sinister Networks. All rights
reserved. May not be redistributed or modified without permission of
Sinister Networks. Do not fold, spindle, or mutilate. Fnord.
Other names and marks used in here are the property of their respective
owners, until and unless decided otherwise in a valid court of law. The
absence of a service mark,
trademark symbol or fnordmark in connection with the marks identifying
products or services of other vendors does not indicate
the absence of registration of those marks or devices. All marks identified
herein are used or registered in the United States of
America and may or may not be used and/or registered in other countries
and planets.